Opening book details…
Can I read A Water-based System for Ceramic Injection Moulding on EtoBox?
A Water-based System for Ceramic Injection Moulding by R.J. Huzzard; S. Blackburn is a Materials Science article available to read on EtoBox.
What is A Water-based System for Ceramic Injection Moulding about?
## Water-based binders for injection moulding of ceramics use low moulding temperatures allowing moulding and die temperatures to be similar. Most of the binder system can be driven ofs as water vapour, cutting process time, reducing burn-out problems and causing less environmental pollution. The dtficulties with removing moulded articles from the die must be overcome. To address this problem, gel strength was measured on solutions up to 8 wt% of ten commercially available cellulose derivatives at four temperatures between the gel temperature and the boiling point of water. A paste with rheology that permits mould filling was made from the binder that showed highest gel strength. This was used in moulding trials. A similar formulation based on a low-strength binder was also studied for comparison. The paste based on the highest gel strength binder showed signtficantly less deformation on release from the die, allowing the processing advantages of the system to be realised.
Who reads A Water-based System for Ceramic Injection Moulding?
It is typically read by researchers, students, and practitioners in Materials Science.
- Author
- R.J. Huzzard; S. Blackburn
- Publisher
- Elsevier Science; Elsevier ; Elsevier BV (ISSN 0955-2219)
- Published
- 1997
- Language
- EN
- Field
- Materials Science (Physical Sciences)