Can I read Influence of oxygen partial pressure on the structural and dielectric properties of Ba(Zr0.3Ti0.7)O3 thin films grown on (LaAlO3)0.3(Sr2AlTaO6)0.35 (001) using pulsed laser deposition on EtoBox?

Influence of oxygen partial pressure on the structural and dielectric properties of Ba(Zr0.3Ti0.7)O3 thin films grown on (LaAlO3)0.3(Sr2AlTaO6)0.35 (001) using pulsed laser deposition by D.Y. Wang; P. Yun; Y. Wang; H.L.W. Chan; C.L. Choy is a Engineering article available to read on EtoBox.

What is Influence of oxygen partial pressure on the structural and dielectric properties of Ba(Zr0.3Ti0.7)O3 thin films grown on (LaAlO3)0.3(Sr2AlTaO6)0.35 (001) using pulsed laser deposition about?

Epitaxial Ba(Zr 0.3 Ti 0.7 )O 3 thin films were grown on (LaAlO 3 ) 0.3 (Sr 2 AlTaO 6 ) 0.35 (001) single-crystal substrates by pulsed laser deposition at 700 °C in different oxygen partial pressures ranging from 6.7 Pa to 40.0 Pa. A strong correlation is observed between the structure and dielectric properties for the Ba(Zr 0.3 Ti 0.7 )O 3 thin films. The tetragonal distortion (ratio of in-plane and out-of-plane lattice parameter, a/c) of the films depends on the oxygen partial pressures. a/c varies from 0.989 at 6.7 Pa to 1.010 at 40.0 Pa, indicating the in-plain strain changes from compressive to tensile. The in-plain strain (either compressive or tensile) shifts the Curie temperature of the Ba(Zr 0.3 Ti 0.7 )O 3 thin films dramatically. Surface morphology and dielectric properties of Ba(Zr 0.3 Ti 0.7 )O 3 thin films have a strong dependence of the oxygen partial pressure. The film grown 26.7 Pa, which corresponds to a moderate in-plain tensile strain and a Curie temperature of ~30 °C, shows the largest relative permittivity, tunability and the best figure of merit in a broad frequency range (1 kHz-500 MHz), which may be a promising candidate for room-temperature microwave devic

Who reads Influence of oxygen partial pressure on the structural and dielectric properties of Ba(Zr0.3Ti0.7)O3 thin films grown on (LaAlO3)0.3(Sr2AlTaO6)0.35 (001) using pulsed laser deposition?

Author

D.Y. Wang; P. Yun; Y. Wang; H.L.W. Chan; C.L. Choy

Publisher

Elsevier Science; Elsevier ; Elsevier Sequoia; Elsevier BV (ISSN 0040-6090)

Published

2009

Language

EN

Field

Engineering (Physical Sciences)