Opening book details…
Can I read Plastics -- Acquisition and presentation of comparable single-point data -- Part 1: Moulding materials on EtoBox?
Plastics -- Acquisition and presentation of comparable single-point data -- Part 1: Moulding materials by ISO/TC 61/SC 2 Mechanical behavior is a reference work available to read on EtoBox.
What is Plastics -- Acquisition and presentation of comparable single-point data -- Part 1: Moulding materials about?
ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions. The properties included are those presented conventionally in manufacturers' data sheets. ISO 10350-1:2007 applies predominantly to unreinforced and reinforced thermoplastic and thermosetting materials that may be injection- or compression-moulded or prepared as sheets of specified thickness. Part 2 of ISO 10350 deals specifically with long- or continuous-fibre-reinforced plastics. For the purposes of ISO 10350, long-fibre-reinforced plastics are considered to have fibre lengths greater than 7,5 mm prior to moulding.
Who reads Plastics -- Acquisition and presentation of comparable single-point data -- Part 1: Moulding materials?
It is typically read by working professionals who need an authoritative practice reference.
Common subject areas: medicine, law, business, engineering.
- Author
- ISO/TC 61/SC 2 Mechanical behavior
- Publisher
- ISO
- Published
- 2007
- Language
- EN
- Category
- reference
More by ISO/TC 61/SC 2 Mechanical behavior
Browse all works by ISO/TC 61/SC 2 Mechanical behavior
Similar books
- Plastics - Acquisition and Presentation of Comparable Multipoint Data - Part 1: Mechanical Properties — ISO/TC 61/SC 2 Mechanical behavior (2001)
- Rubber. Acquisition and Presentation of Comparable Single-point Data — British Standards Institute Staff (2008)
- Plastics -- Acquisition and Presentation of Comparable Multipoint Data -- Part 1: Mechanical Properties
- Plastics. Thermoplastic Polyurethanes for Moulding and Extrusion. Preparation of Test Specimens and Determination of Properties — British Standards Institute Staff (2014)
- Plastics. Polyethylene (PE) Moulding and Extrusion Materials. Preparation of Test Specimens and Determination of Properties — British Standards Institute Staff (2016)
- Plastics. Polypropylene (PP) Moulding and Extrusion Materials. Preparation of Test Specimens and Determination of Properties — British Standards Institute Staff (2016)