Can I read Plastics. Polyethylene (PE) moulding and extrusion materials. Designation system and basis for specifications on EtoBox?

Plastics. Polyethylene (PE) moulding and extrusion materials. Designation system and basis for specifications by British Standards Institute Staff is a reference work available to read on EtoBox.

What is Plastics. Polyethylene (PE) moulding and extrusion materials. Designation system and basis for specifications about?

This standard BS EN ISO 17855-1:2014 Plastics. Polyethylene (PE) moulding and extrusion materials is classified in these ICS categories:. 83.080.20 Thermoplastic materials. 1.1. This part of ISO 17855 establishes a system of designation for polyethylene thermoplastic material, which may be used as the basis for specifications. 1.2. The types of polyethylene plastics are differentiated from each other by a classification system based on appropriate levels of the designatory properties. density,. melt mass-flow rate,. and on information about the intended application and/or method of processing, important properties, additives, colorants, fillers and reinforcing materials. 1.3. This part of ISO 17855 is applicable to all polyethylene homopolymers and to copolymers of ethylene having a content of other 1-olefinic monomers of less than 50 % (mass fraction) and a content of non-olefinic monomers with functional groups up to a maximum of 3 % (mass fraction). It applies to materials ready for normal use in the form of powder, granules or pellets, unmodified or modified by colorants, additives, fillers, etc. This part of ISO 17855 does not apply to masterbatches or to EPM rubber. This part

Who reads Plastics. Polyethylene (PE) moulding and extrusion materials. Designation system and basis for specifications?

Author

British Standards Institute Staff

Publisher

BSI British Standards Institution

Published

2014

Language

EN

ISBN

9780580771866

Category

reference