Can I read Characterisation of Micro Gears Produced by Micro Powder Injection Moulding on EtoBox?

Characterisation of Micro Gears Produced by Micro Powder Injection Moulding by B.Y. Tay; N.H. Loh; S.B. Tor; F.L. Ng; G. Fu; X.H. Lu is a Engineering article available to read on EtoBox.

What is Characterisation of Micro Gears Produced by Micro Powder Injection Moulding about?

The paper describes the fabrication of micro gears of diameter and height 1 mm by micro powder injection moulding. 316L stainless steel powder of 2.4 μm (d 50 ) is mixed with a multi-component wax-based binder system. The feedstock is then injection-moulded into micro gears followed by debinding and sintering. The microstructure of the micro gear at its tooth and hub is studied by electron backscattered diffraction. The average grain size at the hub is ~5 μm. However, a high content of annealing twin and a significant grain growth is found at the tooth.

Who reads Characterisation of Micro Gears Produced by Micro Powder Injection Moulding?

Author

B.Y. Tay; N.H. Loh; S.B. Tor; F.L. Ng; G. Fu; X.H. Lu

Publisher

Elsevier Science; Elsevier ; Elsevier BV (ISSN 0032-5910)

Published

2009

Language

EN

Field

Engineering (Physical Sciences)