About this document

PWM Control with TMR2 in PIC16F887 by Mafa Guillén is a document available to read on EtoBox.

Here are the basic steps to generate a PWM signal using CCP1 module in PWM mode on a PIC microcontroller: 1. Configure the CCP1 module for PWM mode by setting appropriate bits in the CCP1CON register. 2. Set the desired PWM period by writing a value to the PR2 register. This will determine the frequency of the PWM signal. 3. Write a duty cycle value to the CCPR1L register and additional bits to CCP1CON register (DC1B1 and DC1B0). This sets the pulse width for the PWM output. 4. Ensure the timer TMR2 i

Author

Mafa Guillén

Language

EN