About this document
NetWorker BMR Boot Issue on Windows 2008 by puneetgoyal100 is a document available to read on EtoBox.
This document describes an issue where Windows 2008 cannot boot after a successful BMR recovery using NetWorker 8.0.x. The root cause was not determined. There are two suggested workarounds: 1) configure the active partition using DISKPART commands, or 2) rebuild the boot configuration data using the BOOTREC /REBUILDBCD command. Rebooting works fine after BMR recovery using NetWorker 8.1.1.
- Author
- puneetgoyal100
- Language
- EN