About this document

Sequential Motor Control with PLC and SCADA by Jagadeesh k v Jagadeesh is a document available to read on EtoBox.

This document describes a project to sequentially operate three motors using a PLC and SCADA. The key elements are: 1. A PLC will be programmed using ladder logic to start each motor in sequence with a 30 second delay between motors. 2. SCADA software will be used to develop a control interface with buttons to start and stop the motor sequence. 3. Contactors controlled by the PLC will be used to power each motor individually. Overload relays on each motor will provide feedback to the PLC. 4. The SCADA

Author

Jagadeesh k v Jagadeesh

Language

EN