Skip to content

Opening book details…

Can I read Machining of Light Alloys: Aluminum, Titanium, and Magnesium on EtoBox?

Machining of Light Alloys: Aluminum, Titanium, and Magnesium by Diego Carou,J. Paulo Davim is a book available to read on EtoBox.

What is Machining of Light Alloys: Aluminum, Titanium, and Magnesium about?

Cover 1 Half Title 2 Title Page 4 Copyright Page 5 Table of Contents 6 Preface 8 Editors 10 Contributors 12 Chapter 1: Light alloys and their machinability 16 1.1 Introduction 17 1.2 Properties and applications 17 1.2.1 Aluminum 17 1.2.2 Magnesium 19 1.2.3 Titanium 21 1.3 Machinability of aluminum 22 1.3.1 Cutting temperature 23 1.3.2 Cutting forces 25 1.3.3 Cutting tools 26 1.3.4 Tool wear 27 1.4 Machinability of magnesium 29 1.4.1 Cutting temperature and ignition 29 1.4.2 Cutting speeds 30 1.4.3 Cutting tool 31 1.4.4 Tool wear 31 1.5 Machinability of titanium 32 1.5.1 Cutting temperature 32 1.5.2 Cutting forces 34 1.5.3 Cutting tools 34 1.5.4 Tool wear 36 1.5.5 Chatter 36 1.6 Cryogenic machining of light alloys 37 1.7 Conclusions 38 References 39 Chapter 2: Investigation on the built-up edge process when dry machining aeronautical aluminum alloys 50 2.1 Introduction 50 2.2 Experimental set-up 52 2.2.1 Chip morphology and BUE formation 52 2.2.2 Evolution of cutting forces and contact length 54 2.3 Thermomechanical modelling 56 2.3.1 Simulation of the chip formation process 56 2.3.2 Simulation of the BUE process 58 2.4 Conclusion 61 References

Author
Diego Carou,J. Paulo Davim
Language
EN

More by Diego Carou,J. Paulo Davim

Browse all works by Diego Carou,J. Paulo Davim

Similar books